Queue Sender的意思|示意
队列发送方
Queue Sender的网络常见释义
队列发送者 JMS集群第1部分 - 网页制作参考 者（QR，Queue Receiver）从MQ1得到消息，并在该连接关闭之前一直保留到MQ1的连接。队列发送者（QS，Queue Sender）向分布式队列DQ发送消息。只有一个物理队列成员得到发送给分布式队列的消息，而且如图所示，QS发送的第
Queue Sender相关短语
1、 sender queue 发送者队列
Queue Sender相关例句
In a queue-based system, there is an explicit third party (the queue) where messages the sender must put messages and the receiver get messages from.
在队列系统中，总会存在一个显式的第三方队列系统，发送者放入消息，接收者再从中取出。
The message Sender will then await acknowledgement - a confirmation or rejection from the external system - to decide if it will move the message onto the success or reject queue.
Message sender会等待回执(来自外部系统的确认或拒绝)，以决定将消息移动到成功队列还是拒绝队列中。
Each channel has two ends: a sender channel that is defined within the originating queue manager, and a receiver channel that is defined within the destination queue manager, as shown in Figure 4.
每个通道都有两个端点：在起始队列管理器内定义的发送端(sender)通道和在目的队列管理器内定义的接收端(receiver)通道，如图4中所示。
The sender, similar to the RM Source, keeps monitoring the Queue for messages to be sent, identifies them, and immediately sends them to the RM Source.
与RM Source中相似，发送方将持续监视Queue，以获得要发送的消息，并将对这些消息进行标识，然后立即将其发送到RM Source。
The sender does not have the access rights needed to place the message in the destination queue.
寄件人没有将讯息放到目的伫列所需的存取权限（本页面可能为英文）。
The inbound transport chain, with which the sender channel on the WebSphere MQ queue manager communicates, is dependent on the configuration of the WebSphere MQ sender channel.
入站传输链（WebSphere MQ 队列管理器上的发送方通道与之进行通信）依赖于 WebSphere MQ 发送方通道的配置。