crank center的意思|示意

美 / / 英 / /

曲柄中心


crank center的网络常见释义

曲柄中心 ... center crank engine 中间曲柄机 center crank arm 中间曲柄臂 crank center 曲柄中心 ...

crank center相关短语

1、 center-crank 中心曲柄

2、 center crank 中间曲柄

3、 center crank engine 中间曲柄机

crank center相关例句

It can measure the oil film thickness, oil temperature, crank Angle, speed, journal center locus and minimum oil film thickness of main bearing in diesel engine.

该系统可测量内燃机主轴承的油膜厚度、油膜温度、曲轴转角、转速、轴心轨迹和最小油膜厚度。

TDC (top dead center) - the position of the crank and piston when the piston is farther away from the crankshaft.

(上止点)-当活塞离曲轴最远时,曲柄和活塞的位置。

Because the crank only swings back and force within limit, therefore, the dead center in circular motion is overcome, and the crank can make power in the most ideal Angle range.

由于曲柄只作有限度的来回摆动,从而克服了圆周运动中的死点,并能在最理想的角度范围内作功。

The peak value of initial heat release is decreased and its corresponding crank angle moves close to the top-dead-center along with the increased combustion duration.

燃烧初期放热尖峰出现时刻对应的曲轴转角有所提前,瞬时放热率峰值下降;