pitch of gear的意思|示意

The principle straightness error of cutting square in work-pieces can be controlled by choosing a suitable pitch diameter of the planetary gear in the machine tools.

选取适当的车头行星轮的分度圆直径，可以有效地控制车方原理的直线度误差。

The polar equation of non-circular gear pitch curve, calculation method of center distance, formula of pitch curve length, primary circle radius and pressure Angle is given.

给出了非圆齿轮的节曲线极坐标方程，两齿轮中心距的计算方法，节曲线长度、基础圆半径和压力角的计算公式。

According to the fundamentals that pure-rolling must take place between the pitch line of hob and the pitch curve of gear workpiece, the 4 axis complicated simultaneous-control relation was obtained.

从滚刀节曲线与齿轮工件节曲线之间必须进行纯滚动出发，推导出联动关系为4个坐标的复杂联动。

Figures 5 and 6 are the surface separation topologies of worm gear cut by hob cutter with pitch diameters of 74 and 73.6 mm, respectively.

图5和图6是表面分离拓扑减少蜗轮滚刀刀与音高直径74和七十三点六毫米分别。

However, after shaved by shaving cutter with true involute profiles, there are the "mid-concave" phenomena on the pitch points of shaved gear tooth profiles inevitably.

然而用标准渐开线齿形剃齿刀剃齿后，在工件齿形节点附近会出现不同程度的“中凹”现象。

This paper has analysed load distribution of gear ring which is affected engaged deviation and cumulative pitch error, and comparing three analysis results.

对啮合偏移和周节累积误差分别和共同对轮齿载荷分布的影响进行了分析，并将分析结果进行了比较。